← Build log
Rust RepairSeptember 17, 2026

Both front floors in, second coat in the trunk

The passenger side is in. Floor pan and toe board, fitted, clamped, and tacked around the edges the same way the driver's side went. That makes both front floors new metal, and for the first time since the cutoff wheel came out, you can look across the car and not see the shop floor through it.

This side went quicker than the first one. The driver's side taught me where the pan wants to sit against the rocker and how much to leave at the tunnel, so there was a lot less trimming and a lot less climbing in and out.

Meanwhile the trunk got its second coat. POR-15 wants the next coat on while the first still has some grab to it, so Jennifer came back, kicked her sandals off, and climbed all the way in. There is a picture of nothing but her legs sticking out of the trunk opening, and another one I took from inside the car, looking back through the rear bulkhead, where she's grinning through the hole with a brush in her hand. Two coats, wall to wall. The trunk is done.

Next is wire brushing the rest of the interior floor and getting the old seam sealer out, so the floors can get the same treatment the trunk just got.

Share thisFacebook

← Driver's side in, passenger side outWelded in and sealed up →