Sparks today. The driver's side floor pan and toe board are in the car. All the trimming and clamping from yesterday paid off, the panels sat where they were supposed to, and the tacks went around the edges without chasing any gaps.
With that side in, the cutoff wheel moved across the tunnel. The passenger side floor is cut out now, same plan as the driver's side, take only what's rotten and leave the good metal alone. The new pan is sitting in the hole and I'm working on the fit. Same rule applies over here. It gets trimmed until it's right, then it gets welded.
The best part of the day happened at the other end of the car. Jennifer gloved up, poured a cup of POR-15, and painted the trunk. Floor, sides, up into the hinge pockets, all of it. It went from tired gray primer to semi-gloss black, and it's the first finished surface on this car. When we said she isn't afraid to get her hands dirty, this is what we meant.
Next up is getting the passenger side fitted and welded, and then the floors get the same black the trunk got.
← Driver's floor, rough cutBoth front floors in, second coat in the trunk →