← Build log
Rust RepairSeptember 23, 2026

Rear floor comes out, front clip goes black

Short day, but the car looks different on both ends.

The rear floor got the cutoff wheel. Under the rear seat, where the floor meets the brace, the metal was gone. Not thin, gone, daylight through it. That section is cut out now, back to solid steel on every edge, and it'll get a patch the same way the front floors did. Cut only what's rotten, weld in what's needed, seal the seam.

Then it was on to the front clip. The subframe is out on jack stands, cleaned up and powder coated semi-gloss black. Every crossmember and mount is coated, and it's ready for the suspension to start going back on. That's the first piece of the rolling chassis that's actually finished.

The first upper A-arm went through too. Ball joint and bushings out, wire wheeled, prepped, and sprayed the same semi-gloss black as the subframe. Looking at it on the table, it's hard to believe it came off the same car as the floor in the first picture. Three more arms to go.

Share thisFacebook

← Welded in and sealed upFloor's done, glass is out, jack is dead →